Loading... Please wait...

5C, 5" Collet Chuck with Integral D1-6 Camlock Mounting, #0269-0016

Hover over image to zoom

  • Image 1
  • Image 2
  • Image 3
  • Image 4
  • Image 5
  • Image 6
  • Image 7
  • Image 8
  • Image 9
  • Image 10
  • Image 11
  • Image 12
  • Image 13
  • Accuracy T.O.R checking profile
Accusize Industrial
9.50 KGS
Calculated at checkout

Sorry but this item is currently unavailable. Please check back at a later stage.

 Product Description

5C 5" Collet Chuck with Integral D1-6 Camlock Mounting, Stud = 5/8", #0269-0016

  • Please don't buy this item unless you are familiar with this type of product. Thanks.
  • Outside diameter: 5-1/2"
  • Spindle: D1-6 cam lock
  • No. of stud: 6
  • Diameter of stud: 7/8"
  • Integrated D1-6 back mounting. Install on the machine in seconds, no machining required
  • Can be used on any lathe with D1-6 cam lock mounting
  • Customers don't need to do any work when received, just mount it on your machine spindle and go.  
  • Can use any size 5C collet Round collet: 1/16 ~ 1-1/8"; Hex collet: 1/8" ~ 7/8";Square Collet: 1/8" ~ 3/4"
  • Scroll and pinion design just like 3-jaw chuck ,  operated with chuck key. 
  • Scroll & pinion precision machined and hardened
  • Max. RPM 6000
  • TIR: 0.0006"
  • 2-Pinion low profile type


    scroll & pinion are hardened and finish ground
  • Use for turning, facing, boring, grinding and milling operations


    Includes wrench and mounting bolts

The method of measuring 0269-5C Collet Chucks

1.    Check the runout of lathe spindle first. Adjust the runout value of nose within 0.004mm; of cylinder or taper within 0.004mm shown asbelow.


2.    Then put the 5C chuck onto the lathe spindle nose, with the setting hole at the right position to fix each other (While measuring, we used the screw lock device shown in picture-1. We did not have cam lock device shown in picture-2. They work theoretically the same, by different methods.)


3.    After putting the 5C fixture into the measuring equipment, enable the screw lock or the cam lock to work with the chuck on the measuring equipment. Please be noticed to tighten the cam screws in multiple strokes crossly.

4.    Approach the surface of the taper hole with a micron indicator; then rotate the measuring equipment slightly. Reading and noting the micrometer’s value. Tighten the one or two cam screws to correct the 5C fixture, until the runout value within 0.006mm.



5.    Applying the standard 5C measuring bar, use two lock gears to tighten it slightly. And assure the run-out of the 5C fixture orifice, 0.015mm.




 Product Videos

Accusize Industrial Tools - Inspection Method for 5C Collet Chuck
  • Accusize Industrial Tools - Inspection Method for 5C Collet Chuck

What's News


Copyright 2018 Accusize Industrial Tools. All Rights Reserved.
Sitemap | BigCommerce Premium Themes by PSDCenter